Using Ca Glue As A Finish
Using Ca Glue As A Finish. I bought the regular and not the gel but have heard of people using the gel with good results. Discussion starter · #1 · oct 31, 2012.
Cyanoacrylate glue, or ca for short, is commonly known by trade names such as super glue and krazy glue. It requires you to shape the pen in the way you want, sand it, and then apply coats of cyanoacrylate (ca) glue. You may have to use both ends of an applicator on a single pen if it took lomger for some reason and the glue became a hard lump.
The Hot Stuff Ca Glue Finish Set The Unfinished Piece Horizontally And Wipe Off All Wood Dust.
What does adding an extra layer of plastic finish yield. Apply ufo thin or hot stuff to a small area and, using a ca glue spreader card or business card, move the instant glue around to cover as much area as possible. I get 2 pens per applicator most of the time because there are 2 ends.
I Use The Same End Of The Same Applicator To Apply 3 To 5 Coats Of Ca On A Pen Because The Ca Is Still Soft In The Applicator.
Repeat until the surface has been coated. Once the finish is applied, rub it out to achieve either a wet look or a finish as matte as bare wood. It seems that ca is a very popular finish with those who turn acrylics.
I Apply A Few Coats, Flat Sand It, Apply A Final Coat Then Sand To 3000 Grit, Then Give It A Polish By Hand.
They apply the ca while the pen is spinning, sanding between coats, and build up the layers until they have got to the required finish. After several coats of thin ca glue, i usually step up to medium ca glue to build up the finish. Then i use 2 more coats of either medium or thick ca to add to the finish.
Allow Them To Cure Between Coats.
Start with a clean, dry surface. Dark streaks and knots (dark ca. I then lightly sand using 400 and then 600 grit sand paper to smooth the ca on the blank.
The Following Is How I Use Ca Glue As A Finish For My Pens.
I use 3 coats of a very thin ca which soaks into the pen blank. It requires you to shape the pen in the way you want, sand it, and then apply coats of cyanoacrylate (ca) glue. This type of finish also works on larger pieces such as bowls, hollow forms or vases.
Post a Comment for "Using Ca Glue As A Finish"